
iPoint NVR v5.16 Server Manual
2. DVR Server
2.1 Start Up
Before you press the NVR power button, please check that all connection interfaces are firmly
connected. Press the NVR system power button, then the application interface will display later
(the time will be decided by how many channels the system has installed, each channel needs
about 4-5 seconds).
If NVR Autostart has been deleted from start up please double click icon
on windows
desktop. The main application interface is as follows
:
1
2
10 11 12 13 9
16
8
Figure1-1-1
*Note: If this is the first time the system is run after installation, the operator should setup the
resolution of the compression card.
4
Comentarios a estos manuales