MSI 865PE Neo3-F Manual de usuario descargar pdf (Pagina 22)

iPoint NVR v5.16 Server Manual

Sensor group set up is very similar to the group set up of camera recording.

【Sensor Type】Select N/C or N/O alarm type.

【Alarm Write log】Select write alarm log or not.

【Alarm Action After It Times-Out】Select system alarm linkage mode after an alarm time-out. “Stop

Immediately” means the system stop alarm immediately after the alarm driver stops an alarm. “Follow

Input State ” means the system don’t stop alarm after the alarm driver stops an alarm. “Delay” means

the system will stop alarm at your setting time after the alarm driver stops an alarm.

【Sensor input】Add sensor to selected group.

【Start recording cameras】Select which cameras respond with this sensor group. They will start

recording and auto connect remote network client when there is an alarm.

【Trigger Output Relays】Add alarm devices (alarm out port) to this group. E.g. siren, light. All

connecting devices will send alarm message when there is an alarm.

Schedule Setup (Example for below figure)

Figure1-3-8

1. Check Alarm (Red): DVR System responds with sensor in this time. (00:30 to 12:00 from Sun. to Fri.)

2. Not Check (gray): DVR System doesn’t respond with sensor in this time.

Note: If you setup groups with conflicting camera, then only the last setup is going to work.

2.3.4.

PTZ & Linkage Setup

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

Sin comentarios

MSI 865PE Neo3-F Manual de usuario Pagina 22