MSI K8M Neo-V Manual de instrucciones descargar pdf (Pagina 12)

Floppy Disk Drive Connector: FDD1

The mainboard provides a standard floppy disk drive

connector that supports 360K, 720K, 1.2M, 1.44M and 2.88M floppy disk types.

IDE Connectors: IDE1 & IDE2

The mainboard has a 32-bit Enhanced PCI IDE and Ultra DMA 33/66/100/133 controller that provides

PIO mode 0~4, Bus Master, and Ultra DMA 33/66/100/133 function. You can connect up to four hard

disk drives, CD-ROM, 120MB Floppy and other devices.

The first hard drive should always be connected to IDE1.

IDE1 can connect a Master and a Slave drive. You must configure second hard drive to Slave mode by

setting the jumper accordingly. IDE2 can also connect a Master and a Slave drive.

MSI Reminds You...

If you install two hard disks on cable, you must configure the second drive to Slave mode by setting its

jumper. Refer to the hard disk documentation supplied by hard disk vendors for jumper setting

instructions.

Serial ATA/Serial ATA RAID Connectors controlled by VT8237: SATA1,

SATA2

The southbridge VIA VT8237 provides a hybrid solution that combines two independent SATA ports for

support of up to two Serial ATA (Serial ATA RAID) drives and supports RAID

levels 0 or 1 for easy management of the storage subsystems. Both connectors

support 1st generation serial ATA data rate of 150 MB/s and are fully compliant

with Serial ATA 1.0 specifications.

Fan Power Connector: CFAN1/SFAN1/PWFAN1

The CPUFA1 (processor fan) supports system cooling fan with +12V. It supports three-pin head

connector. When connecting the wire to the connectors, always note that the red wire is the positive

and should be connected to the +12V, the black wire is Ground and should be connected to GND. If the

mainboard has a System Hardware Monitor chipset on-board, you must use a specially designed fan

with speed sensor to take advantage of the CPU fan control.

+12V

GND

SENSOR

GND

RXP

RXN

GND

TXP

TXN

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 88 89

Sin comentarios

MSI K8M Neo-V Manual de instrucciones Pagina 12