MSI MS-9105 Manual de instrucciones descargar pdf (Pagina 29)

Hardware Setup

2-13

Hard Disk Connectors: IDE1 & IDE2

The mainboard uses an IDE controller on the VIA

VT8233 chipset that

provides PIO mode 0-4, Bus Master, and Ultra DMA 33/66/100 modes. It has

two HDD connectors IDE1 (Primary) and IDE2 (Secondary). You can connect

up to four hard disk drives, CD-ROM or 120MB Floppy to IDE1 and IDE2.

IDE1 (Primary IDE Connector)

- The first hard disk drive should always be connected to IDE1. You can

connect a Master and a Slave drive to IDE1.

IDE2 (Secondary IDE Connector)

- You can connect a Master and a Slave drive to IDE2.

Primary IDE Connector

Secondary IDE Connector

TIP

If you install two hard disks on cable, you must configure the

second drive to Slave mode by setting its jumper. Refer to the

hard disk documentation supplied by hard disk vendors for

jumper setting instructions.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 81 82

Sin comentarios

MSI MS-9105 Manual de instrucciones Pagina 29