MSI MS-9238 Guía de usuario descargar pdf (Pagina 12)

AOC-SG-i4 Add On Card User’s Manual

2-2

2-2 Front Connectors, Jumpers and LEDs

This section describes the front connectors, jumpers and LEDs found on the AOC-SG-i4

add-on card.

LAN Ports

LAN ports allow the add-on card to connect to a maximum of four network cables. These

are RJ45 connectors. Each LAN port provides up to one gigabit per second connection

speed which require CAT6 cables for maximum throughput.

The ports are designated LAN1, LAN2, LAN3 and LAN4.

LAN Port LEDs

Each LAN port includes two LEDs. The LEDs indicate connection speed and activity.

See Table 2-2 for definitions of these LEDs.

Front Jumpers and Pin Definitions

When properly configured, this add-on card allows Network Administrators to use STBY

enabled and STBY disabled settings. In addition to configurations required by your

motherboard and software, you must close the J2 jumper on the add-on card to enable

this feature.

Table 2-2. LAN Port LEDs

LED Color Definition

Act Amber (blinking) LAN Activity

LNK

Orange Link speed in Kb/s

Green Link speed in 100 Mb/s

Off No connection or link speed at 10 Kb/s

To modify the operation of the add-on card,

jumpers are used to choose between optional

settings.

Jumpers create shorts between two pins to

change the function of the connector. Pin 1 is

identified with a square pad on the printed

circuit board.

On two pin jumpers, “Closed” means the

jumper is on and “Open” means the jumper is

off the pins.

Connector

Pins

Jumper

Setting

3 2 1

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 37 38

Sin comentarios

MSI MS-9238 Guía de usuario Pagina 12