Msi MS-91F7 2010 Manual de usuario descargar pdf (Pagina 35)

BIOS Setup

▍

MS-91F7

3-7

BIOS Setup

▍

MS-91F7

IDE Conguration

Primary/Third/Fourth IDE Master/Slave

[Type] Press PgUp/<+> or PgDn/<-> to select [Manual], [None] or [Auto] type.

Note that the specications of your drive must match with the drive

table. The hard disk will not work properly if you enter improper infor-

mation for this category. If your hard disk drive type is not matched or

listed, you can use [Manual] to dene your own drive type manually.

[LBA/Large Mode] Enabling LBA causes Logical Block Addressing to be used in place of

Cylinders, Heads and Sectors

[Block(Multi-Sector

Transfer)]

Any selection except Disabled determines the number of sectors trans-

ferred per block

[PIO Mode] Indicates the type of PIO (Programmed Input/Output)

[DMA Mode] Indicates the type of Ultra DMA

[S.M.A.R.T.] This allows you to activate the S.M.A.R.T. (Self-Monitoring Analysis &

Reporting Technology) capability for the hard disks. S.M.A.R.T is a util-

ity that monitors your disk status to predict hard disk failure. This gives

you an opportunity to move data from a hard disk that is going to fail to

a safe place before the hard disk becomes ofine.

[32 Bit Data Transfer] Enables 32-bit communication between CPU and IDE controller

▶

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 44 45

Sin comentarios

Msi MS-91F7 2010 Manual de usuario Pagina 35